CIRUS-Technology
for your VFFS machine
Benefits of CIRUS Technology
Increase the output of your VFFS machines
Boost your cycle rate with the integrated cut & seal process in a single step.
Instant stability of the seam
The integrated water cooling immediately ensures strong, tight seams – no heat‒up or cool‒down phases required.
Maximum employee safety
The cutting profile is built into the tooling, eliminating injury risks from mechanical blades.
Avoidance of changeover times
One heat‒sealing tool for different film sizes, therefore no tool change required.
Material savings
Average around 15 %, due to cut & seal. No material loss due to necessary test runs.
No test runs after each machine start
Get reliable, sealed seams from the very first cycle – unlike conventional systems that waste material on test runs.
No warm‒up and cool‒down phases
Thermal impulses and integrated water cooling eliminate the need for extended warm‒up or cool‒down phases.
Use in humid environment possible
Our “Fluid Secure” tools (IP65) enable safe operation in moist or cleanroom conditions – ideal for pharma and food production.
Why Retrofit with CIRUS?
Annual material savings with CIRUS
Enter your current production figures – we will calculate your annual material savings
Comparison CIRUS vs. Constant Heat
Feature
- Instant stability of the seam
- Temperature control
- Changeover times
- Cycle rates & process time
- Material saving
- Use in humid production environment
- Heat impact to the product
- Warm-up and cool-down phases
- Test runs after each machine start
- Employee safety
CIRUS
- Due to integrated water cooling
- Rapid and accurate. Heating rate: up to 6000 K/s
- One heat-sealing tool for different film sizes
- Due to cut & seal in one process step
- Ca. 15 % due to cut & seal
- Possible due to "Fluid Secure" (IP65)
- Minimal due to active cooling
- No warm-up and cool-down phases
- Not necessary
- No risk because the separation profile is integrated inside the tool
Constant heat
- Low stability due to lack of cooling
- Slow and depending on the temperature sensor
- Depending on format, tool change necessary
- Two process steps
- Not possible
- Usually not suitable for this purpose
- Very high (radiant heat, continuous heating)
- Warm-up & cool-down up to 30 minutes
- Necessary, avg. 20 bags
- High risk of injury for employees due to mechanical cutting knife
Case Study Retrofit VFFS‒machine with CIRUS
CONTACT US
We look forward to your e-mail request.
